Monitor Definitions
| Monitor | Description |
|---|---|
| Added Water Rate | Displays the clean water added to the equipment at this point in the flowsheet |
| Belt Length | Displays the conveyor belt length |
| Belt Width | Displays the conveyor belt width |
| Cost | Displays the cost data that has been saved with the selected Power Source item. |
| Deck Efficiencies | Displays the operating efficiency (calculated or user defined) for each screen deck. |
| Emission | Displays the result of the emission calculation for the selected item. |
| FM | Fineness Module for material less than 37 mm / 1 1/2" |
| Fuel Usage | Displays the fuel usage data that has been saved for an equipment item |
| Gradation Table | Displays a gradation table of the material at the discharge of the selected equipment or flow line |
| Input/Output | For clean water equipment to show the added and used water in the flowsheet |
| Lowest Efficiency | Displays the efficiency of the least efficient deck on the screen. |
| Makeup Water | The difference between the inflow to the water source and the outflow from the water source is the makeup water rate for the plant |
| Measured Rate | Displays the user defined field measurement at this item. |
| Manufacturer | Displays the manufacturer for the selected equipment. |
| Model | Displays the model for the selected equipment. |
| Passing 80% | Displays the size of the material of which 80% is passing that size. |
| Percent Solids | Displays the percent solids in a slurry line |
| % of Source | Displays the percentage of source material (start point) of the stage at the selected inventory item or end product. |
| % TPH Capacity | Displays the percentage of the current flow rate compared to the maximum flow rate for the selected equipment. |
| Power | Displays the installed power for the selected equipment. |
| Power Balance | Displays the installed power for equipment compared to the rated power at the power source. Power factor is not considered in determining the required power. |
| Rated Power | Displays the manufacturer or user defined rated power for that machine. |
| Reduction Ratio | Displays the reduction ratio for the material passing through the selected equipment. |
| Scalper (WxL) | Used for mobile equipment to display the scalper dimensions |
| Scalper settings (Mesh Sizes) | Used for mobile equipment to display the scalper setting |
| Screen (WxL) | Displays the width and length dimensions of the screen. |
| Setting | Displays the setting(s) for the selected equipment. |
| Setting (Mesh sizes) | Displays the screen mesh sizes for each screen deck. These can be individually selected and moved or deleted. |
| Size | Displays the intended size range of material not including screen carryover results. To see the full gradation, use the Gradation Table monitor. |
| Slurry Rate | Displays the flow rate of the combined aggregate and water (slurry). |
| Specific Gravity | Displays the specific gravity of the slurry flow in a slurry pipe or through a slurry pump. |
| Specification | Displays the user selected specification for the inventory item or end product. |
| TPH | Displays the Tons-Per-Hour rate flowing through the selected item. |
| Water Rate | Displays the amount of water only at that point in the flow. |